Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 41 / 136

- 39 -
C
h
p
ater
4
4-5 Composition of Control Circuit Terminals
1) Potentiometer for frequency setting

Please install a 5kΩpotentiometer of 0.3w or above, set the 1st speed frequency and select the frequency
settings of current and voltage by selecting function code F1002.

Please use shielded wires for wiring, please connect one end of the control terminal shield to the shield
terminal ASG, while leave the other end open.

They can be connected to the potentiometer respectively, the power supply terminal of the potentiometer is
the + V common terminal.
The + V terminal can not provide power to the external as it is not a terminal used for supplying power. It is a
dedicated terminal used for connecting the specified potentiometer.
2) Multifunctional output (open collector output)

The figure below shows an example of using multifunctional output terminals D01 to D03.
※
When using a relay, be sure to install a surge suppressor (reverse-parallel connected diode).
Figure 4-2 Example of using multifunctional output (open collector output)
Note: The maximum output current of the multifunctional output is 50 mA.