Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 131 / 136

- 129 -
-
129
-
C
h
ap
ter
1
3
13. Peripheral equipments & options

The following optional boards built into the inverter are available.
Table 13-2 Optional Card
Option Name Type Function Applicable inverter
PG Option card SC-PG1 Detect and feedback the motor speed with the detector (PG), to
operate speed control function and position control function.
・
Line driver output corresponding to PG
・
Pulse (differential pulse) input for phase A & B
・
Pulse monitoring output
・
PG power supply: +5V
SVC06 all models
SC-PG2 Detect and feedback the motor speed with the detector (PG), to
operate speed control function and position control function.
・
Open-collector/push-pull output corresponding to PG
・
Pulse input for phase A & B
・
Pulse monitoring output
・
PG power supply: +12V
SC-PG3 Detect and feedback the motor speed with the detector (PG), to
operate speed control function and position control function.
・
Open-collector/push-pull output corresponding to PG
・
Pulse input for phase A & B
・
Pulse monitoring output
・
PG power supply: +24V
PROFIBUS
communication
board SC-PB The inverter can be used as a slave-station of PROFIBUS with
this option, therefore realizing the monitor and control of
inverter parameter setting and status by the upper master station
through the PROFIBUS bus. SVC06 all models

The inverter can mount 2 optional boards simultaneously.
There are two slots in the inverter; each optional board must be plugged into the specified slot because different
optional boards have different shapes.
Furthermore, the combination status of the optional boards may also influence the installation or function.
For details of each option, please refer to the instructions for each optional board.
Optional board compatibility sheet
Table 13-3 Optional card combination compatibility
Slot 2
Slot 1
Not
plugged
SC-PG1 SC-PG2 SC-PG3 SC-PB
Not plugged -
○ ○ ○
×
SC-PG1
○
× × × ×
SC-PG2
○
× × × ×
SC-PG3
○
× × × ×
SC-PB
○ ○ ○ ○
×
○: Available
×: Not available
・
SC-PB can not be installed only in slot 2.