Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 20 / 136

- 18 -
3-3 Removal and Installation of the Front Cover
(3) Installation
When installing, work in reverse order.
3-3-2 Middle-capacity model
（
SVC06-0185~0750-**4
）
(1) Removal of front cover (lower) and internal sealing plate (iron)
Unscrew the M4 screw on the front cover (lower) and pull down gently, and then the front cover (lower) will be
removed. Then, unscrew 4 M4 screws and remove the sealing plate.

Please carry out this work during the main circuit wiring, control circuit wiring, and SW1 switching.
Figure 3-7 Removal of front cover (lower) and internal sealing plate (iron)
(2) Removal of front cover (upper)
After the front cover (lower) has been removed, unscrew 2 M4 screws on the front cover (upper), and gently push up
front cover (upper), it will be removed.

Please carry out this work during the control circuit wiring (RX and TX), installation and removal of options,
and SW2 switching.
Figure 3-8 Removal of front cover (upper)
(3) Installation
When installing, work in reverse order.
Terminal
block
for control
circuit
Input / output terminal block
M4 screw
Slots for
optional boards
Terminal block for
control
circuit (RX, TX)