Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 113 / 136

- 111 -
-
1
1
1
-
C
h
ap
ter
10
10-3 Part Replacement
Table 10-2 Main circuit power module checklist
Input/Output Terminals Measured value
Mult Multimeter -
Input (R, S, T) P R, S, T Conducted
R, S, T P Not conducted
X R, S, T Not conducted
R, S, T X Conducted
Output (U, V, W) P U, V, W Conducted
U, V, W P Not conducted
X U, V, W Not conducted
U, V, W X Conducted
10-3 Part Replacement
When replacing a part, please contact your supplier or our sales department.
10-3-1 Fan Replacement
When cooling fan is used continuously under the environments with high temperature (40
℃
and above) and
plenty of dust, the service life will be shortened obviously. Therefore, the fan must be checked regularly.
Furthermore, the fan should be replaced duly when there is an abnormal vibration or sound.

Turn OFF the power for replacement. Make sure that the fan is stopped before making a
replacement.
Failure to obey may result in personal injury or electric shock.
（
1
）
Steps for replacing fan of SVC06-0007
~
0075
The fan is on the top of the device.
Step 1 Remove one screw (M3).
Step 2 Hook the cover board with a finger and pull to remove it.
Step 3 Pull out the fan and remove the connector, then make a replacement.
After the replacement, reinstall the fan with a sequence of 3 →2→ 1.
M3 screw Hook here with a finger
Cover board
Fan
Connector
Direction of wind
Figure 10-1 Replacement steps of fan
（
SVC06-0007 ~0075
）