Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 24 / 217

Section 1: System Description
25238802 1-11
Value Button
Pressing the VALUE button will cause the display to show the total dollar amount accepted since the temporary audit
value was cleared. Thus, if you clear this audit counter
(see Section 2) each time you load the hoppers, you can
quickly see how much change has been paid out and thus determine whether or not the bill changer needs to be loaded
again.
Hopper Button
Pressing the HOPPER button will cause the display to show the last three denominations accepted. The most recent
denomination is displayed on the left side, the bill before that is displayed on the right side. If a test vend in included
in this list, the display will show: “
TVL
”, “
TVC
”, or “
TVR
” (depending on which
TEST VEND
switch was pressed)
in its proper position on the display. If a coin was accepted, the display will show “
25
”, “
50
”, or “
$1C
” on the display
in its proper sequential position (left, center, or right position).
When the
PROGRAMMING/NORMAL
switch is moved from
PROGRAMMING
to the
NORMAL
position, the
message “
STORING NEW DATA
” will be displayed.
PROGRAMMING POSITION
Setting the
PROGRAMMING/NORMAL
switch to the
PROGRAMMING
position allows you to inspect and/or change
the audit and setup information. This information is displayed on the status display and is selected and changed by
using the five pushbuttons that are described in the following paragraphs
(see Section 2: Changing Payout
Programming Also) :
Function Button
Advances from the current set of options to the next set. The following list shows the sequence of options that will
be displayed as the
FUNCTION
button is pressed repeatedly:
1. TEMP COUNTERS 6. ACCEPT
2. PERM COUNTERS 7. PAYOUT
3. PROGRAMMING 8. STACKER MODE ALT/SEP
4. MC PAYOUT 9. BILL B CHECK
5. HOP VAL 10. BILL TEST
If the
FUNCTION
button is pressed while
BILL TEST
is showing, the “
TEMP COUNTERS
” display will reappear.
Hopper Button
In the
PROGRAMMING
mode, this button advances the display to the next hopper if the display includes hopper
information.
Value Button
During the
PROGRAMMING
mode, this button is used to move between various values: i.e., the value of coins in
the hoppers, denominations to be accepted, etc.