Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 52 / 217

Section 3: Routine Service
INTRODUCTION
In order to maintain control over money used for change dispensing, each changer should be loaded with a
predetermined amount of cash. The inventory should be checked monthly as a precaution against malfunction and
theft. Inventory control is most easily accomplished by using the replacement method of servicing. Using this method,
all bills and coins are removed by the route man and the empty hoppers are refilled with a predetermined amount
of change. The money removed is returned and all cash is counted against the charged inventory. Any discrepancy
is easily detected at this time.
Service frequency on the changer is directly related to the inventory of change maintained and customer usage. Check
changer usage daily and schedule service as required.
REMOVING THE BILL ACCEPTOR FROM A BC-1400
1. Unlock and open the door to the changer.
2. Remove the two bill boxes (item 1) .
3. Push the center test vend pushbutton (item 2) (to cycle the stacker), and when the stacker is in the
OUT
position,
turn the power to the changer off (
OFF/ON
switch - item 3) .
4. Loosen and remove the two knurled thumbscrews (item 4) .
5. Unplug the transport harness (item 5) and the stacker harness (item 6) .
6. While grasping the transport bracket and the stacker assembly, slide the entire assembly straight back until the
unit is removed.
7. The bill acceptor can now be removed by sliding it out through the front.
8. Reinstall by following the above steps in reverse, with the exception of pushing the test vend pushbutton.
25238802 3 - 1