Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 77 / 217

BC-1200/1400 Bill and Coin Changer
4 - 6 25238802
VALIDATION REJECTS
Cell Sequence Rejects
REJECT - SHORT VI
Symptom:
The inlet cell was covered for too short of a time.
This is a reject message.
The bill was rejected because the VI cell was not covered long enough. The bill may have been torn on the right
side, torn, or folded over at the trailing edge of the bill. If bills are rejected frequently with this code, the VI cell may
be giving an intermittent signal.
Corrective Action:
1. Check the VI cell for proper switching.
2. If the cell is OK, check the wiring from the VI cell to the CCC for a possible short to the chassis, or an open
to the CCC (P4 - Pin 14).
3. The +5 VDC supply to the LEDs may be below 4.5 VDC; check the voltage. If it is low, replace regulator
VR802 on the power control center (see the components list for the power supply circuit board).
4. If all of preceding checks are OK, replace the CCC.
If the bill is left in the transport for five seconds, the machine will go into
SELF-CLEAR.