Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 33 / 217

BC-1200/1400 Bill and Coin Changer
2 - 8 25238802
LOADING THE HOPPERS
Review Figure 2-5 before you begin.
1. Pull the hopper forward to its stop point.
2. Twist the top of a full coin bag one full turn. Grasp
the twisted top with one hand and hold the bottom
of the bag with the other. Invert the bag and insert
the top into the mouth of the hopper.
3. Slowly release the twist as the bag empties. Avoid
spilling coins into the changer. Empty the bag by
grasping it at the bottom and shaking it to dislodge
coins in folds of the bag. Push the hopper back into
place.
4. Load the change escrow buckets with change by
pressing each of the three
TEST VEND
switches one
at a time. Repeat this process for each test switch
and verify that the change that was dispensed is
correct.
5. Coin I.D. stickers are supplied with the machine to
identify the coin denominations in each hopper.
Attach one of these stickers on each hopper so that
the coin denomination can easily be identified.
UNLOADING THE HOPPERS
Refer to Figure 2-5 and unload the hoppers as follows:
1. Remove the hopper bail wire. (See Figure 1-1A.)
2. Pull the hopper forward to its stop point.
3. Place the opening of the coin bag over the mouth of the hopper, wrapping the lip of the bag around the handle.
Grasp the bag and handle with one hand, tilt the hopper back, release the latch, and slowly tip the hopper
forward while holding the bag against the front of the hopper.
NOTE:
Hoppers may be loaded with either dollar coins, quarters, dimes, nickels, or tokens
unmixed depending on the type of hopper used. Make sure that the value of coins loaded
into the hopper agrees with the values programmed into the computer during the
HOPPER VALUE (HOP VAL) step of the setup.
Figure 2-5. Loading the Hoppers