Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 48 / 217

Section 2: Installation & Programming
25238802 2-23
3. Use the
^
and
^
buttons to establish the maximum number of bills to accept (“
X
”), then press the
HOPPER
button and “
Y
” will begin flashing. Use the
^
and
^
buttons to set the time lime (in minutes) for the changer to
accept “
X
” bills. Pressing the
HOPPER
button again will cause “
Z
” to begin flashing. Use the
^
and
^
buttons
to select the number of minutes for the changer to remain shutdown should the limits be exceeded. Note that
choosing the
INF
setting will require you to open the changer and press the
FUNCTION
button in order to
restore the changer to service.
4. Pressing the
VALUE
button will cause the next enabled denomination to be shown. Repeat Step 3 for each
of these denominations.
5. Pressing the
VALUE
button after you’ve established the limits for the highest denomination enabled will cause
the display to show “
ALL OFF
”. Using the
^
and
^
buttons as before, you can establish limits for all accepted
bills regardless of denomination.
6. Press the
VALUE
button to step back through your settings. When you have everything set as you like, slide
the
PROGRAMMING/NORMAL
switch to the
NORMAL
position
ANTI-PULLBACK SYSTEM
Certain Changers may be repeatedly exposed to vandals attempting to cheat the machine by inserting a bill and then,
after collecting the change, attempting to retrieve that bill by pulling it back out of the stacker using an attached string.
The changer provides several mechanical and electrical systems to prevent anyone from being successful in these
attempts, but such activities could lead to jams in the transport and the attendant service calls.
As an added deterrent the changer allows you to set up a special temporary
OUT OF SERVICE
condition if the
computer detects that the transport motor has moved during a time when it was turned off.
If this feature is enabled, the computer monitors the encoder signal of the transport motor during periods when the
motor should not be turning. The action of pulling a previously accepted bill from the machine will invariably cause
the motor to be turned. Even a very slight movement will be detected, and when it does the Control Computer takes
the following action:
The motor is instantly turned
ON
in the reverse direction. This will assist in keeping the transport free of jams. The
Display will “freeze” and the motor will continue to run in reverse for about 3 seconds. At this time the changer will
go
OUT OF SERVICE
with the display showing “
PLBK dDhh=mm AGO
”, where
dD
= the number of days,
hh
= the
number of hours, and
mm
= the number of minutes that have passed since the changer went
OUT OF SERVICE
for
this reason. This time will continue to increment and will be displayed even after the temporary shutdown condition
expires and the changer goes back into normal service – it can only be cleared by pressing the
FUNCTION
button.
(When you clear this timer, the display will briefly show “
PLBK TIMER CLR’D
”.)
CAUTION!
When this feature is enabled, do not attempt to turn the transport motor drive gear manually with the
transported connected and the Power ON. As described above, the motor will start instantly when
motor movement is detected.