Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 93 / 217

BC-1200/1400 Bill and Coin Changer
4-22 25238802
Machine Errors
There are two types of machine errors —
SHUTDOWN
and
NON-SHUTDOWN.
Shutdown errors are errors which
could cause damage to the machine or incorrect payouts.
NON-SHUTDOWN
errors are errors involving coin
switches, test switches and the bill return switch.
When a
NON-SHUTDOWN
error occurs, the switch or switches involved will be locked out of operation. Bill
acceptance will not be affected. All machine errors are stored in the CCC and displayed on the status display during
STANDBY. NON-SHUTDOWN
errors are displayed steady without blinking. All
SHUTDOWN
errors are displayed
as blinking messages with the out of service lamp lit. The CCC can remember up to five errors, however, there will
never be more than one shutdown error, as this will cause the machine to go out of service. All faults or malfunctions
that cause errors must be repaired and the errors cleared from the CCC before the machine can go back to service.
Clearing Machine Errors
Clearing machine errors is done by simply pushing the
FUNCTION
button while the error is displayed. As each error
is cleared, any previous errors will be displayed on the CCC. Press the
FUNCTION
button to clear each error. After
all errors are cleared and no faults or malfunctions are left in the machine, it will return to the
STANDBY
state.
Changer Errors (Non-Shutdown)
None of these errors cause the bill changer to shut down. While the bill changer is in
STANDBY,
the last error will
remain on the display.
CK LEFT TEST SW
Symptom:
The left
TEST
switch was closed longer than three seconds.
Corrective Action:
The
LEFT TEST
switch input is (or was) showing an incorrect signal.
In order to prevent spurious payouts, the CCC immediately locks out all
TEST
switch inputs if it receives an incorrect
signal from one of the
TEST
switches. Thereafter, the bill changer will still accept bills but will not respond to the
TEST
switches.
Press the
FUNCTION
button. If the message does not reappear, check the wiring to the
TEST
switches for intermittent
short to Ground. If the wiring is OK, the problem may be an intermittent condition in the CCC.
For a more complete troubleshooting sequence, refer to Troubleshooting Chart 010 at the end of the TEST
SWITCH troubleshooting.