Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 36 / 217

Section 2: Installation & Programming
25238802 2-11
13. Perform this step only if you set the stacker mode to “
SEP
” in the above step. To assign the bills to the upper
or lower bill box, press the
VALUE
button to go through each denomination you have set to “
YES
” for
acceptance, and push either the
^
or
^
button to stack these bills in either the “
UPPER
” or “
LOWER
” bill boxes.
14. Press the
FUNCTION
button once and the display will show “
BILL B CHECK ON
” or “
OFF
”. Use the
^
or
^
button to select either
ON
or
OFF
. This is a security check made during the bill validation process. Rowe
recommends the “
ON
” setting for all but the most extreme circumstances where a very high percentage of bills
are rejected with Code “B” (see Section 4) .
15. Press the
FUNCTION
button once and the display will show “
BILL TEST OFF
”. Use the
^
or
^
button to select
OFF
.
16. Setup is complete! Place the
PROGRAMMING
switch back down to the “
NORMAL
” mode. The display will
show “
STORING NEW DATA
”, and then the “walking dash” will appear. Fill the hoppers with quarters, do
a test vend from each of the test switches: left, center, and right (located on the power control center), and the
job is completed.
Normal Setup
This procedure follows the “beginning-to-end” setup sequence. You should follow this procedure and use it until
you are familiar with the ten groups of setup options. Once you are familiar with these options, you can easily skip
over the options that you do not wish to change or display.
Key Information
In the step-by-step procedure that follows, key setup information follows many of the numbered steps. This
information will be very helpful, but it can be skipped. Key information paragraphs are indicated by a small to
the left of the key paragraph.
Turning the Power On
1. Be sure the
PROGRAMMING/NORMAL
switch on the CCC is in the
NORMAL
position, then turn the power
switch
ON
. Three of the four voltage LED’s on the power control center should now be
ON
. The +40 VDC
LED will be
OFF
. The
OUT OF SERVICE
light will be lit.
2. The message “
ROWE FAST PAY
” will be followed by “
VERSION XX
” on the display.
XX
is the version
number and should match the version number on the EPROM label, which is visible through the cover of
the CCC.
3. The message “
CHECKSUM XXXX
” will briefly appear on the display.
XXXX
is the 16-bit EPROM checksum.
4. Next, the “
RAM TEST PASSED
” (or “
FAILED
”) message will briefly display. If the word
FAILED
appears, the
changer will remain in the
OUT OF SERVICE
mode.
5. When the “
RAM TEST PASSED
” message disappears, the
CHECKING SYSTEM/SYSTEM CHECK OK
“walking dash” will appear. The +40 VDC LED will light and the
OUT OF SERVICE
light will turn
OFF
.