Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 131 / 217

BC-1200/1400 Bill and Coin Changer
4-60 25238802
DETAILED CONTROL COMPUTER BOARD OPERATION
The following description is not intended for the casual repair person or the novice technician. It details the electronics
found on the control computer board. No attempt should be made to repair this board unless you have had
considerable experience troubleshooting and repairing complex, microprocessor-controlled electronic circuit
boards. Rowe suggests that you send any defective CCC boards back to the factory for proper servicing.
Figure 4-5 is a four-sheet schematic of the 65077458 Changer Control Computer board. Sheet 1 shows the
microprocessor, memory, and address decoding circuits. Sheet 2 shows the 16-character alphanumeric display and
its control circuits. Sheet 3 shows the output interface circuits. Sheet 4 shows the input interface circuits.
Sheet 1: Control Computer
U20 is a 8097 microprocessor. It has eight channels of analog-to-digital conversion on it used to process analog
signals coming from the transport. There are also a number of special high-speed input and output pins along with
several I/O port pins. The CMOS version of the microprocessor (80C196) may be used in place of the NMOS
8097. When the CMOS version is used, the crystal frequency must change from 12 MHz to 3 MHz, and jumper
J1 must be in the 1-2 position. J1 must be in the 2-3 position when the NMOS 8097 microprocessor is used.
RESET CIRCUIT
The reset circuit is based on the U21, which is a low-voltage detector circuit. Voltage is applied to Pin 2 from the
5-volt regulator VR1. When the input voltage on Pin 2 reaches the proper level, the Reset output on Pin 1 goes
HIGH
.
When Reset goes
HIGH
, U20 Pin 16 also goes
HIGH
, taking the processor out of reset. Reset also goes to the base
of Q18, which controls RAM selection, battery power, and the switched 12-volt source.
With U21 Pin 1
LOW
(
RESET
active), Q18 is OFF. R74 will pull down the base of Q9, Q17, and Q20, keeping
all three turned
OFF
.
With Q9
OFF
, the RAM chip select from U12A Pin 3 is blocked form reaching the RAM, U10. R73 pulls the RAM
chip select up and keeps it deselected.
With Q17
OFF
, Q15 stays
OFF
, allowing the battery voltage to be applied to the RAM. U10 Pins 26 and 28 through
R150. The battery voltage will allow the RAM to retain its memory during
RESET
and whenever there is no power
applied to the board.
With Q18
OFF
, Q20 is kept
OFF
by R107, which in turn keeps Q13
OFF
, which leaves the switched 12-volt supply
OFF
.
When U21 Pin 1 goes
HIGH
(
RESET
not active), Q18 su5 volts to the bases of Q9, Q17, and Q18, turning
each of them
ON
.
CAUTION:
Damage to the microprocessor (V20) may result if the J1 jumper is installed wrong. Use position 1-
2 for the CMOS 80C196 and position 2-3 for the NMOS 8097.