Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 42 / 217

Section 2: Installation & Programming
25238802 2-17
15. Press the
FUNCTION
button to advance to the
BILL B CHECK ON/OFF
mode selection. Press either the
^
or
^
button to switch between the
ON
and
OFF
mode.
The normal position for standard validation (
BILL B CHECK ON
) provides maximum security against bogus
bills. This is the factory setting and Rowe strongly recommends its use for all but the most severe
environments.
The
BILL B CHECK OFF
position improves acceptance of bills which are contaminated with metal chips or
dust, but also reduces protection against bogus bills.
16. Press the
FUNCTION
button to advance to the
BILL TEST ON/OFF
mode selection. Press either the
^
or
^
button to switch between
ON
and
OFF
.
The
BILL TEST
mode will allow you to test bill acceptance without disturbing any of the other machine
functions.
If the
BILL TEST
is not desired, leave the mode set to
OFF
and go on to Step 17 .
To operate under the
BILL TEST
mode, leave the option
ON
then move the slide switch to the normal
position. The display will show “
STORING NEW DATA
”, then “
BILL TEST MODE
”. At this time, any bills
inserted into the transport will be validated normally. If the bill is accepted, it will be stacked in the bill
stacker and the display will show “
GOOD $X
”, where
X
is the denomination just accepted. The machine will
not payout change, will not advance the dollars accepted counter, and will not advance the audit totals while
in the
BILL TEST
mode.
If a bill is rejected, the display will show the normal reject message. See Section 4 for an explanation of the
reject messages.
There are three ways to leave the
BILL TEST
mode: You can go back into the
PROGRAMMING
mode and
set the
BILL TEST
mode to
OFF
, or you can simply turn the
POWER
switch
OFF
then back
ON
. The third
way is a safety feature where the machine will automatically return to the
NORMAL
mode two minutes after
the last test bill was inserted (remains “
IDLE
” for 2 minutes).
17. Pressing the
FUNCTION
button will send the computer back to the beginning of the entire programming
sequence (“
TEMP COUNTERS
” will show on the display) and you may review your setup by stepping
through each function again.
To return the bill changer to normal operation, move the slide switch from the
PROGRAMMING
position to the
NORMAL
position. The display will show “
STORING NEW DATA
” and then the “walking dash” again.