Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 55 / 217

BC-1200-1400 Bill and Coin Changer
3 - 4 25238802
FILLING AND EMPTYING THE BC-1200/1400
The dispensing mechanism operates on an escrow principle. Change for a vend must be in the escrow buckets when
the customer inserts a bill. After change is dispensed, the buckets must immediately refill for the next customer.
Because of this, certain steps must be followed when filling or emptying the changer, or when resetting the changer
if it has shut down.
FILLING THE CHANGER
When filling a changer that is empty, the coin buckets must be filled with their proper load of coins before the machine
can be put into operation. After the hoppers have been loaded and are in place:
1. Turn the power switch
ON
and depress the
LEFT TEST SWITCH
once. This will start the hoppers and load
the left coin bucket with the proper coins.
2. Wait until the hopper motors have all stopped and press the
LEFT TEST SWITCH
again. Proper change should
be dispensed and hopper motors will start to refill the bucket again.
3. Repeat steps 1 and 2 for the
CENTER TEST SWITCH
and
RIGHT TEST SWITCH
. The machine should now
be ready for operation.
EMPTYING THE CHANGER
To empty the changer of all coins, first empty both hoppers according to instructions on the label on the door. When
the hoppers are emptied, some coins will remain in the change buckets. Press the test switches, one at a time, to
release these remaining coins. Turn the power switch
OFF
and then
ON
between each test switch operation.
Figure 3-2. Transport Check Points