Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 39 / 217

BC-1200/1400 Bill and Coin Changer
2-14 25238802
Operation in the
MC
mode can be described simply as follows:
The computer will get the total required number of coins from any hopper or hoppers that it can. If both
hoppers are operational, it will divide the required payout amount (say, 20 quarters for a $5 bill for example)
by two and replenish ten coins from each hoppers for the count of 20.
Should a hopper go empty, the computer will simply begin using the other hoppers. If only one hopper
remains as “good”, the computer assumes the machine is nearly empty and will attempt on successive vends
to obtain coins from both hoppers again – hoping to find that the changer has been filled. If it has, the
computer will simply continue using both hoppers again – if it has not, it will run on the last operational hopper
until it is empty, and at that time the machine would go into the OUT OF SERVICE (or SHUTDOWN)
mode.
Operation in the NON-MC mode:
This mode must be used if the hoppers are loaded with coins or tokens of different values. The count
required from each individual hopper must be satisfied during each replenish cycle, or the machine will go
into the OUT OF SERVICE (or SHUTDOWN) mode.
6. Press the
FUNCTION
button and the display will change to “
HOP VAL - - - - - -
”.
The
HOP
per
VAL
ue option allows you to select the denomination of the coins or tokens that will be
dispensed from each hopper (see Table 2-3 for the list of denominations) . If a hopper value is set to
dashes (- -), that hopper will not dispense any coins at any time.
The computer must know the value of coins used for one important reason. The changer supports a “correct
payout feature” – the computer simply will not allow you to program a payout that does not total the amount
taken in unless you set at least one hopper value to tokens. The correct payout feature prevents
programming errors and the resulting over or underpayment.
7. The left two dashes will be blinking. Press the
VALUE
button to step through the possible hopper
denominations. If in the
MC
mode (see Step 5 of this procedure) , both values will change simultaneously.
When the correct hopper value is displayed, press the
HOPPER
button to advance to the right hopper
options if in the
NON-MC
mode; or press the
FUNCTION
button to advance to the
ACCEPT
function if in the
MC
mode (skip ahead to Step 9 ).
8. The right two dashes will be blinking. Since there is no center hopper, two dashes will remain on in the center
position. Press the
VALUE
button to step through the possible hopper denominations. Stop when the
correct hopper denomination is displayed.