Rowe BC-1200, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 41 / 217

BC-1200/1400 Bill and Coin Changer
2-16 25238802
11. After you have programmed the denominations you wish to accept, press the
FUNCTION
button to move on
to the
PAYOUT
function.
12. The display will show:
XXX PAY - - - - - -
. The
XXX
will be the lowest bill denomination set to
ON
.
The left digits will be blinking. If in the
MC
mode, the center and right pairs of digits will simply show
MC
, and
pressing the
HOPPER
button as described in the following paragraph will have no effect. If in the
MC
mode
and tokens have been selected for the hopper values, see Dispensing MC Tokens at the end of this section.
13. Press the
^
or
^
button to increase or decrease the coin count for the selected hopper. Press the
HOPPER
button to move from one hopper to the next.
Once you have the counts set as you want for the displayed denomination, press the
VALUE
button to
advance to the next denomination you chose to accept. If you have made an error and the payout value is
not equal to the displayed denomination, the display will briefly show “
INCORRECT PAYOUT
” and then
return to the same denomination – refusing to advance. This is true unless you have set one or more of the
hopper values to one of the token values. You will not be able to leave this display, even if you put the
PROGRAMMING/NORMAL
switch in the
NORMAL
position. (Upon returning the switch to the
PROGRAM-
MING
mode, the display will show “
TEMP COUNTERS
”).
When the
VALUE
button is pressed and held for more than two seconds, the display will show “
XXX PAYS
- - - -:
”. The
XXX
represents the current denomination. The - - - - will show
TOKENS
if tokens are loaded into
any hopper; or if only coins are used, the display will show the total dollar value of the coins to be paid out.
Once you have programmed the payout for all the denominations being accepted, press the
FUNCTION
button to advance to the
STACKER
mode selection.
14. The display will show “
STACKER MODE ALT
” (or “
SEP
”). Press either the
^
or
^
button to switch between
ALT
ernate and
SEP
arate.
If you choose
ALT
ernate, the bill stacker will stack one bill in the top bill box and the next bill in the bottom
bill box regardless of the bill denomination. No further explanation is needed, go directly to Step 15 in this
procedure.
If you choose
SEP
arate, the changer will separate the bills by denomination. Press the
VALUE
button to
select the desired bill box for each denomination selected:
When the
VALUE
button is pressed, the display will show “
STACK
”, the lowest bill denomination enabled
(usually $1), and the word
UPPER
or
LOWER
. Pressing either the
^
or
^
button will cause the display to
change between the two options and, of course, the stacker operations will be as displayed.
Press the
VALUE
button to step through all of the accepted bill denominations. Set each one to the bill box
of your choice.