TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 275 / 290
WiFi Access Point
Supported standards
IEEE 802.11 b/g. Optionally also wireless N (802.11n) available, with
support for dual antennas.
Operation Modes
Configurable as Access Point, Station or Bridge
Connection Modes
Infrastructure, Ad-Hoc
Wireless security
WEP – 64 or 128 bits
WPA, WPA2 – PSK or PSK 2 crypto
MAC Filtering
TKIP, AES
Mobile antenna
External multi-band antenna with magnetic base and cable
Two different types are shipped; one for GSM/3G and another for LTE
(4G) modules in varioaus frequency. In care of 4G modules, which feature
antenna diversity (MIMO), two LTE antennas may be used.
GPS antenna
For GPS-enabled modem modules, a GPS antenn is available.
WiFi antenna
Stick antenna with 90
o
bending
N-type has MIMO support (connectors for two wireless antennas) thus two
WiFi antennas are required.
Supply voltage
12 V
D.C
. (+ center wire, - external conductor)
Supply adapter
Standard - special switching mode power adapter for 230V AC mains
Output : 12 V
D.C
. / 2.1 A
Input: from 100 to 240 V
A.C
. / 0,3 A / 50 Hz
Optional car kit adapter, for powering from the car battery
Optional wide voltage range supply, form 9 up to 48 V
DC
input (by factory
order)
Status indicators
LEDs, for POWER, DATA, WiFi and SGN (level of signal), plus two LED
per each LAN or WAN port.
Temp. range
Operating: Standard 0
0
... +70
0
C
Optional Industrial: -25
o
C … +75
o
C (Sierra Wireless modules)
Optional Industrial: -30
o
C … +80
o
C (SIMCOM modules)
Storage: up to -40
0
..+85
0
C for no more than 96 hours
Humidity: 0 to 95%, non-condensing
IP Classification
Ingress Protection Rating:
IP 20
Chassis
Material
Ruggedized metallic case
Dimensions
(L x W x H)
210 x 130 x 30 (mm) except protrusions
Installation
Horizontal mounting, on a flat surface
DIN Rail mounting possible by means of a mechanical adapter
Weight
Tipically 0,400 Kg, Maximum 0.800 Kg (equipment box only)
Tipically 1 Kg – whole package
