TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 137 / 290
5.3.3. WAN Port
Whenever you use an Ethernet interface for WAN connection, you must fill in the settings “IP Settings for
the WAN Ethernet Interface”.
Figure 5-63: Webpage for setting up WAN Port in the WAN settings.
Address Type
: options are Static or DHCP Assigned.
.Default is “
DHCP Assigned
”, which means that
the IP address of the WAN Ethernet Interface will
be automatically assigned by a DHCP server.
Note that in this case the fields following this option
are inactive, as shown below.
They are colored in gray, because you
cannot
write
values into them.
Figure 5-64: Selection of address type (Automatic) for WAN Port in the page for WAN.
See the corresponding Routing Table for Automatic WAN (the ppp1 link has been stopped)
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
192.168.148.0 0.0.0.0 255.255.255.0 U 0 0 0 wan
172.27.0.0 0.0.0.0 255.255.0.0 U 0 0 0 lan0
192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0 wan
When you select ”Static” instead of DHCP, then you must also fill in the:
IP Address
value on the WAN
side,
Netmask
for this address
, and address of the
Gateway
used for routing.
You must also specify the name servers.
