TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 48 / 290
5.1.3 Manual IP Settings
As an alternative, you can set the network parameters manually. By default, Bytton LTE has the IP
address
192.168.1.1
and the standard Netmask 255.255.255.0, and these settings are used in the
example below. However, it does not make sense to use manual settings for the
default configuration
,
rather you should use manual settings if your local network has some special requirements, which the
automatic configuration cannot satisfy.
In case of manual settings, in “Internet Protocol
Properties” you must fill in the corresponding
values:
- the IP address could be from 192.168.1.2 up
to 192.168.1.254; to be sure you don’t fall over
the address of another device of your LAN, a
value of 11 is suggested, instead of 2 which is
the absolute minimum available value
- the Subnet mask must be the standard one,
255.255.255.0
- the Default gateway must be 192.168.1.1
- the same address 192.168.1.1 is to be used for
the “Preferred DNS server” .
Figure 5-5: Manually establishing IP parameters
for the connection to Bytton
In the status bar at the bottom of the screen you should see the link icon blinking, and a message
will show up: “Bytton LTE is now connected”.
An alternate example of manual settings, when the
IP address of Bytton LTE is 10.0.0.1:
Note:
When you use for your local network a Proxy Server, you must set an exception for Bytton ICR
wireless router, because otherwise you won’t be able to access the
Bytton LTE
equipment!
You should enter the IP address of the Bytton LTE device (by default 192.168.1.1) in the list of
exceptions for the Proxy server: “Do not use proxy server for addresses beginning with …”
