TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 49 / 290
5.1.4 First Connection
To configure the Bytton LTE
product using the web interface, just open your favorite web browser
and type the default IP address as the URL:
https://192.168.1.1/
as shown:
Figure 5-6: Enter the default IP address of the Web page into your browser.
If you cannot connect to the
Bytton LTE
router because of problems in the settings of the IP
address, you must go back to the factory default settings. Press the “RESET” button for at least three
seconds. The equipment reboots and starts operating with the factory default settings.
These include the IP address 192.168.1.1, allowing you to connect to the Rohde & Schwarz
Topex S.A. wireless router in order to configure it.
After reaching the configuration web pages at the default IP address, you may change the IP
address of the device according to your requirements!
For
instance,
you
can
use
addresses
in
the
range
https://172.27.168.xxx/
or
https://10.0.58.1
,
as
shown in this example:
Figure 5-7: Changing the default IP address
of Bytton LTE.
5.1.5 Secure Connection HTTPS
Note that Bytton LTE uses a
secure web connection
(https) so
you
may
get
several
warning
messages like this one:
Figure 5-8: Security Alert for the
https connection.
or similar warnings mentioning “Website Certified by an Unknown Authority”:
