Ricoh MPC 2800 AT-C2, Руководство по обслуживанию на месте, Страница: 534 / 856

2111 [Forced Line Position Adj.]
001 Mode a -
Executes the fine line position adjustment twice.
If this SP is not completed (NG is displayed), do
SP2111-003 first and then try this SP again.
002 Mode b -
Executes the fine line position adjustment once.
If this SP is not completed, do SP2111-003 first and
then try this SP again.
003 Mode c -
Executes the rough line position adjustment once.
After doing this SP, make sure to execute
SP2111-001 or -002. Otherwise, the line position
adjustment is not perfectly done.
2112 [TM/ID Sensor Check] ID Sensor Check FA
001 Execute
This SP is used to check the ID sensors at the factory.
The results of this SP are displayed in SP2140 to
SP2145.
2117
[Skew Adjustment]
Specifies a skew adjustment value for the skew motor M, C or Y.
These SPs must be used when a new laser optics housing unit is installed or when SC285
occurs. For details, see “Laser Optics Housing Unit” in the "Replacement and Adjustment"
section.
001 Pulse: M *ENG
[–100 to 100 / 0 / 1 pulse/step] 002 Pulse: C *ENG
003 Pulse: Y *ENG
2118 [Skew Adjustment]
001 Execute: M *ENG Changes the current skew adjustment values to the
values specified with SP2117.
These SPs must be used when a new laser optics
housing unit is installed or when SC285 occurs. For
details, see “Laser Optics Housing Unit” in the
"Replacement and Adjustment" section.
002 Execute: C *ENG
003 Execute: Y *ENG
8. Appendix: SP Mode Tables
178
8