R&S AFQ100A
Default Settings
1401.3078.62 1.21
E-3
Default Settings
The instrument is set to a defined state with common command *RST or the
Alt
+
P
key combination
on an external keyboard.
The following table gives an overview of the presets for the most important generator settings. The
other presets can be found in the preset tables of the individual menus and the information
accompanying the IEC/IEEE-bus commands.
Functions that concern the integration of the instrument into a measurement setup are not changed,
e.g. IEC/IEEE bus address or reference oscillator source settings.
The list below the table shows the settings that are not affected by the
PRESET
key.
Reference frequency
internal, calibration off
Offsets 0
Modulations switched
off
IEC/IEEE-bus address
not changed
With preset, all parameters and switch states are preset, including those of deactivated operating
modes. Presettings beyond those in the above list can be seen in the preset tables in chapter 4 or from
the *RST values of the associated IEC/IEEE bus commands.
Settings that are not affected by the
PRESET
key
Reference frequency settings (Ref Oscillator dialog)
Network settings (Setup menu)
IEC/IEEE-bus address (Setup menu)
Password and settings protected by passwords (Setup menu)
Start/Stop Gui Update (Setup menu)
Display and keyboard settings (Setup menu).
Save and Recall settings
Windows XP
NOTICE
Functions of the instrument may be impaired!
Using not specifically authorized software may impair instrument functions.
Drivers and programs used in the instrument under Windows XP have been adapted to
the modulation generator. Existing software
must only be modified
with update
software released by Rohde & Schwarz. Likewise,
only programs authorized by
Rohde & Schwarz
for use on the instrument
must be executed
.
The following program packages have been successfully tested for compatibility with
the measurement instrument software:
Windows XP Remote Desktop
Symantec Norton AntiVirus – Virus-protection software
