R&S AFQ100A
Baseband Block
1401.3084.32 4.23
E-3
Bus
The segment trigger event is executed by remote
control using the command
TRIG:SEGM:EXEC
.
Remote-control command:
SOUR:TRIG:SEGM:SOUR BUS
Auto
(segment mode Single or Repeat N Times only)
The segment trigger event is executed internally
by the firmware. Segment trigger events are
ignored.
Remote-control command:
SOUR:TRIG:SEGM:SOUR AUTO
Note:
The trigger source
Auto
disables the segment
trigger modes
Continuous
and
Continuous
seamless
and vice versa.
Segment Address -
Segment Trigger
Selects the segment sequence mode of a multi segment waveform.
Note:
The
Segment Address
mode can be selected only by using
external segment trigger sources such as
Manual
,
External
or
Bus
. With segment trigger source
Auto
the Segment Address
mode is not displayed.
With the aid of external signals the sequence of the segments can be
set. The signals are fed in via the BERT BNC connectors at the rear
panel of the instrument. These control signals for segment hopping
can be fed in parallel or serial.
Note:
The Segment Address mode
FHOP
disables the
BERT
functionality and vice versa.
Auto Increment
The indices of the segments are incremented
automatically.
Remote-control command:
SOUR:WSEG:NEXT:MODE AINC
