511026 Rev. 07-01-19
149
8.6.3 Using the Manual Release
To manually release the magazine, insert a small flat head screwdriver into the appropriate
magazine release hole and gently push the tab.
!
IMPORTANT
Do not exert force once you encounter resistance. Doing so can
damage the device.
8.7
Unloading a Stuck Tape
If a tape is stuck in a tape drive, eject the tape from the drive from the
Operation > Force Drive Media
Eject
screen. Before performing this option, it is recommended that you attempt to eject the tape using
the backup software or library move media operation.
If a tape is stuck in a magazine, open the magazine, grasp the cartridge, and pull it out of the storage slot.
8.8
Returning the Robotic Assembly to the Base Module
When the Q40 is powered off the robotic assembly should return to its parked position in the Base
Module behind the OCP. If the robotic assembly does not return to its parked position:
•
Power on the library by pressing the power button on the Base Module just below the OCP.
•
From the RMI, navigate to the
Maintenance > Move Robotic to Base Module
page. Select the
Submit button to initiate the move.
•
Power off the library by pressing and holding the power button on the Base Module for 3 seconds.
If the robotic assembly is still not in the Base Module, use one of the procedures in the following two
sections.
