Q40 Tape Library
Installation and Operations Manual
511026 Rev. 07-01-19
138
7.10.5 After the Robotic Assembly and Spooling Mechanism Installation
1.
Push the left magazine back into the module until it locks into place.
2.
Replace the top cover on the Base Module if you removed one
3.
Slide the module into the rack.
4.
If there are no adjacent modules, tighten the front screws
.
5.
If there are adjacent modules:
Set the alignment mechanisms to the lock position. If you encounter resistance, adjust the
upper module so the pin in the alignment mechanism moves into the hole in the lower module.
6.
Reconnect the expansion interconnect cables.
7.
Reconnect the Ethernet, SAS, and Fibre Channel cables to the Base Module
.
8.
Reconnect the power cords
.
9.
Pack the failed robotic assembly and spooling mechanism to return to Qualstar Technical Support
.
7.10.6 Powering On the Library
Power on the library by pressing the power button on the Base Module just below the OCP; the green
light will illuminate. When the library is powered on, it inventories the tape cartridges in the magazines,
checks the firmware version on all modules, configures the tape drives, confirms the presence of the
existing modules, and searches for any new modules.
7.10.7 Verifying the Installation
1.
To verify that the library powers on and initializes correctly, check that the status LED is Ready.
2.
If the UID LEDs are still illuminated, deactivate them using the RMI.
3.
Resume all host applications.
7.11 Replacing the Front Bezel or OCP
CAUTION
Parts can be damaged by electrostatic discharge. Keep parts in
electrostatic containers until needed. Ensure you are properly
grounded when touching static sensitive components.
7.11.1 Powering Off the Library
Power off the library from the front panel. Press and hold the power button for 3 seconds. If the library
does not perform a soft shutdown, press and hold the power button for 10 seconds.
Verify that the robotic assembly is in its parked position.
Verify that all host processes are idle.
7.11.2 Removing the Bezel
Remove the magazines.
Insert a small flat head or Torx screwdriver into the bezel release holes at bottom of the unit
.
Push the screwdriver until the bezel is released.
Pull the bezel up
NOTE
If removing a Base Module bezel, pull gently to avoid damaging the OCP
cable. Note where the OCP cable is located, routed and attached.
