EN
OperatiOn
1800_EN-Einsatz_2723
- 26 -
TIP
The lowering speed of the rotor can be adjusted with the
throttle on the lifting cylinder.
• for TOP 612 C Standard
• for TOP 702 C/ TOP762 C only with optional
equipment hydraulic working width adjustment
Settings on rotor chassis
Requirements:
- level and firm ground
- 1.5 bar pressure in all tyres
- The implement is attached to the tractor and in the
working position
Setting cross slope
(only with the optional tandem chassis)
To ensure clean raking, the rotor chassis should
be slightly inclined towards the swath. The side
rake start should be approx. 1.0-1.5 cm higher.
1. Lower the rotor unit using the crank (1) - until the inner
tines just touch the ground.
TIP
After adjustment, secure the crank (1) using the
retaining clip.
1
2. Setting the outer tines using eccentric bolt (2) - approx.
1.0 - 1.5 cm above ground.
3
2
b1
a. Loosen nuts (3) slightly using a size 36 open-end
spanner.
b. Set the required inclination using the eccentric bolt
(2) and a size 36 open-end spanner.
c. Re-tighten the nuts (3). (Tightening torque 280 Nm)
TIP
All the wheels (a-c) can be set in this way.
The wheels on the same side of the gyro unit (a1, a2
and b1, b2) should be adjusted to the same height.
Adjusting rake height
TIP
It is not necessary to adjust the chassis and inner feeler
wheel height with every change in the rake height.
1. Set rake height using the hand crank handle (1) for
each rotor unit individually. Turn crank handle (1)
anti-clockwise to increase the distance of the tines to
the ground. Turn crank (1) clockwise to decrease the
distance of the tines to the ground.
- The inner tines should just sweep over the ground
(approx. 2.0 cm) depending on fodder amount.
