- 17 -
1800-DE_Anbau_2723
EN
AttA
Att
Att
ching the mA
ching the m
ching the m
chine
Fit cardan shaft
- Switch engine off and remove ignition key.
- Clean and grease the termination bars of the
implement and the pto of the tractor before fitting
the cardan shaft.
- >first fit the wide-angle joint with the freewheel at the
implement. Then attach cardan shaft to the tractor
pto.
- Secure the protective tubes of all cardan shafts
against rotating by attaching the securing chains.
DAN
DANgER
life-threatening danger exists when cardan shaft
length is unadapted
•
Before initial operation, check the length of
the cardan shaft and adapt if necessary.
•
A tractor change is considered to be an
initial operation.
•
See chapter "Adapting the Cardan shaft" in
Appendix B.
025-05-04
L2
Shortest possible operating position (L2):
1. Lower hoist completely
2. Steering turned to lock.
(see adjacent Figure)
T rimming procedure
- To adjust the length, hold cardan shaft halves in the
shortest operating position (L2) next to one another
and mark.
See Chapter "Adjusting the cardan shaft" in attachment B
to these Operating Instructions for details.
Rope
- Lay the rope (S) into the tractor cab.
Securing of unbraked devices by means
of a tear-off chain
The operator must protect unbraked devices against loss
during travel by means of a tear-off chain. Mounting points
on the device side depend on the type of connection. Please
refer to the illustrations below:
1. Breakaway chain for lower link hitch:
2. Breakaway chain for rigid drawbar:
094-18-403
Rotor stabilisation
Factory settings:
- Distance between centre of gyro and spring holder
on tracing wheel arm: 540 mm (only TOP 612)
- Retaining spindle (1) of the stabilisation spring and
end of the adjustment bracket are of same length
