Preparing Your Laboratory
65
The Avio 200 is equipped with an IEC60309 250 V 16/20A 2 pole plus protective
earth plug (PerkinElmer Part No. 09997530) that inserts into an equivalent
IEC60309 series receptacle (Perkin Elmer part number 09290304 or 09290305
surface mount version) both of which are contained in the N0770425 conduit box kit
that ships with the instrument.
As an alternative you can use the following receptacle part numbers which can be
directly ordered from Hubble. For the US/Canada (20A service) use PerkinElmer
Part Number 09997529 Hubble Part No. C320R6SVL or C320R6W. For Europe
(16A service) use Hubble Part No. C316R6S. Also, Conduit Box-Cast Device Back
Box Hubble Part No. SP 20301 is available for the above Hubble versions.
Computer and Printer
Refer to the guides supplied with your computer and printer for electrical
requirements. The computer and printer must share a common earth ground with the
Avio 200.
PolyScience Chiller
The specific electrical requirements for the PolyScience
®
WhisperCool
TM
Chiller
are printed on a serial number label located on the back of the unit. The voltage of
the power source must meet the specified voltage
10%. In addition, an adequate
ground connection must be provided.
For 60 Hz installations,
the PolyScience
®
WhisperCool
TM
Chiller, 60 Hz, 15A unit
is supplied with a 15-ampere, 250-volt Hubbell #4570-C Twist-Lock power plug
(NEMA L6-15P configuration). A Hubbell #4560 or equivalent receptacle (NEMA
L6-15R configuration) is also required, and is supplied with the instrument.
(NEMA: The National Electrical Manufacturer’s Association)
For 50 Hz installations,
to accommodate most countries, the PolyScience 220/240
V, 50 Hz, 15A unit is supplied with two detachable line cords.
Note
PerkinElmer instruments will normally operate within ± 10% of the specified voltage
and within
1% of the specified frequency, unless otherwise noted. If the power line is
unstable, fluctuates in frequency or is subject to surges, additional control of the
incoming power by the user may be required.
The Avio 200 must
not
have a Ground Fault Circuit Interruptor (GFCI) protected outlet.
The instrument will trip the interruptor if this type of outlet protection is used.
Содержание AVIO 200
