Peri RCS P, Инструкция по сборке и эксплуатации, Страница: 127 / 172

127
D3 Moving by Crane
Finishing tasks
1. Detach crane lifting gear from a safe
position, e.g. mobile scaffold. Alter-
natively, leave two-sling lifting gear
attached to the climbing enclosure
until it can be safely dismantled.
2. Supplement guardrails.
3. Dismantle trailing Slab Shoe, see
Section "Dismantling the Suspen-
sion" on page 115.
4. Remove anchoring that is no longer
needed, see Section "Dismantling
the Anchoring" on page 117.
Troubleshooting
Problem Cause Measures
Guiding skids cannot be closed. – Climbing Rail is not completely in
position in the Guide Shoe.
– Pull Climbing Rail inwards with the
Guide-in Tool.
– Slab Shoe spacing is not correct. – Slightly loosen the leading Anchor
Bolt, close the guiding skids and
tighten them using component toler-
ances.
Alternatively:
– Mount new anchoring through
the slab with tie rods and wingnut
counterplates.
Climbing Unit does not lie on the
planned Spacers on both sides. – Climbing Rail rests on a Slab Shoe
that is positioned below.
– Floor height is approx. a multiple of
50 cm.
– Raise the Climbing Unit by approx.
10 cm using the crane. Deactivate
the pawls of all Climbing Shoes
positioned above. Position Climbing
Unit with the planned Spacer on the
pawl of the bottom Climbing Shoe.
RCS P Climbing Protection Panel
Instructions for Assembly and Use – Standard Configuration