
Operation
61
F/T Move
The
F/T Move
command can be used together with the
F/T Waypoint
command, to move the robot
along a route, or together with the
F/T Path
to move the robot along a path and stop once the defined
force/torque limits are reached (movement interrupted). In this case a warning can be generated. If the
movement reaches the last waypoint, the move is successful.
NOTE:
To cancel any force/torque offset, execute an
F/T Zero
command at
the beginning of the
F/T Move
command and make sure the tool is not
in contact with any object before starting the
F/T Move
, otherwise the
command may not stop at the given force/torque limit.
To operate the
F/T Move
command tap on the
Add {{ waypoint.title }}
button to add an
F/T Waypoint
as a child node. More waypoints can be added in the same way. To remove a waypoint, use the
Structure
tab
Delete
button.
Alternatively,
F/T Waypoint
or
F/T Path
could be added as a child node of the
F/T Move
command
by using the
Structure
tab.
Speed
:
The movement speed limit while moving. The movement is carried out in a constant translational
speed. If the route or path has sharp changes in the direction, or the orientation, the actual speed of the
robot may be less than specified, but still constant throughout the route or Path.
Acceleration
: The acceleration and deceleration parameter of the movement.
Coordinate system
:
The coordinate system used both for the movement and for the sensor reading. It
can be set to Base, Tool, Custom (Base), Custom (Tool)
(according to the UR’s reference frames). The
Custom coordinate systems are calculated from the basis coordinate system and the given Roll, Pitch and
Yaw values. For the Custom (Base) coordinate system, it is also possible to use the
Get TCP orientation
Содержание VGC10
