Date
26/6/2017
Document 923860006_09_006
Document code 923860006_09_006
Page 38 from 44
The screen shows information of the selected zone. You can see if it is
installed, the zone’s output current, if the fuse is OK (NORMAL or FAULT),
the current status (MAINS, BAT or OFF)
and the voltage state of the output
(NORMAL or FAULT). By pressing “Esc” you return to the INFORMATION
menu.
If you select LUMINARIES and press “Enter” the system asks for the zone
that the required luminary is installed into. Select the zone and press “Enter”.
Now the system asks for the luminary’s address. Select the required address
and press “Enter” again.
Information concerning the selected address is displayed, as seen on the
screen on the right. The first line “POINT X.YY” refers to the luminary’s
address. Next line indicates whether there is a luminary installed or not under
the specific address. The third line indicates zone number and luminary
address, fourth line luminary type, fifth line communication status and last
line, lamp status (ON/OFF).
If you select PANEL and press “Enter” you can see the screen on the right.
The CURERENT LIMIT shows the total current that is drawn from the
batteries when in emergency mode. The CONS.FROM BATTERY shows the
battery output power in Watts currently. You can also see if the battery fan is
operating (OΝ or OFF) and finally the STATUS which is OK if no fault is
detected and FAULT if an error is detected (on the battery fan). By pressing
“Esc” you return to the INFORMATION menu.
If you select NETWORK and press “Enter” you can see the screen on the
right. In this screen you can see if the Ethernet card is installed and also the
IP and MAC address of the system. By pressing “Esc” you return to the
INFORMATION menu
With the option LAST AUTONOMIES, you can see all the logged autonomy
durations of the system. On the first line you can see 01/ΧΧ (where ΧΧ the
number of logged duration tests) along with the date and time of each logged
event. You can see if the panel is fully charged or not, the duration of the
emergency operation and the battery capacity used. With the “Up/Down”
arrow keys you can change the logged emergency states. By pressing “Esc”
you go back to the INFORMATION menu.
