ODA EX Series, Брошюра и инструкция по эксплуатации

Страница: 71 / 113

EX Series Operating Manual
▌Calculate the current when DVM display voltage became stable.
If resistor is 0.01Ω and DVM display voltage value is 1.23mV,
the current value is 0.123A.
▌Enters a current value that you calculated by using cursor key and ▌Enters a current value that you calculated by using cursor key and
encoder knob.
This is an examples for 60
LCD Display a-LOW 00.12a ampere output power supply.
▌After finished to enter the value, press the "Calibration" key.
LCD Display ADC data 026ch During around 500ms, display
HEX value instead of readback value
LCD Display
3.cal-curr low
Return to before state of Mcalibrating.
▌Move to "4.cal-curr High" mode by using cursor key and press
the "Calibration" key.
LCD Display a-high 61.00a It is able to differ about curr display.
▌Wait until DVM display voltage becomes stable.
▌Calculate the current when DVM display voltage became stable.
If resistor is 0.01Ω and DVM display voltage value is 615mV,
the current value is 61.50A.
Wait for 5 minute.
▌Enters a current value that you calculated by using cursor key and
encoder knob.
This is an examples for 60
LCD Display
a-high 61.50a
ampere output power supply.
▌After finished to enter the value press the "Calibration" key ▌After finished to enter the value, press the Calibration key.
LCD Display
ADC data f500h
During around 500ms, display
HEX value instead of readback value
LCD Display
4.cal-curr high
Return to before state of Mcalibrating.
▌It is finish of current calibration. You can use the power supply
next time by applying this data next time by applying this data.
- 71 -