ODA EX Series, Брошюра и инструкция по эксплуатации

Страница: 35 / 113

EX Series Operating Manual
3-7. Programming Under Current Limit(UCL)
Normally, you can adjust the current from 0V to maximum current but if you set the UCL level,
you can adjust the current from UCL level to maximum current.
▌Turn on the power supply
After turned on, check the power supply displays"
**OUTPUT OFF**
" Mode.
▌Before setting the UCL level, current limit setting value must be higher
than UCL level. And then you can set the UCL limit value.
▌In other to set the current, move the under bar cursor where you want
by using right cursor key and set the current by using encoder knob.
Under the protection(OVP/UVL/OVL) setting state, current cannot be over the
on the display and current value returns to protection level value
protection level. If the level over, "
PROTECTION LIMIT
" message appears
on the display and current value returns to protection level value.
▌Press the "Protection" key in other to set the UCL level.
LCD Display PROTECT> 1.OVP
▌Move to the CVL menu by using right cursor key.
LCD Display PROTECT> 5.ucl LCD Display PROTECT> 5.ucl
▌Press the "Protection" key one more time at the "5. ucl" state.
LCD Display UCL SET> 00.00A
▌Move the under bar cursor location where you want to change.
▌Set the Under Current Level by using encoder knob ▌Set the Under Current Level by using encoder knob.
Note that you cannot set the limit levels to lower than current real output
current in other to prevent the operator's malfunction occurring.
▌After set the limit levels that you want, press the "Protection" Key.
LCD Display CHANGED
After displayed above message, The power supply will exit the UCL
menu and the display will return to the meter mode menu and the display will return to the meter mode.
Cancelling
▌If you don't want to change the UVL levels, just wait during 5 seconds.
Wait 5 sec
LCD Display CANCEL…
≫ Related Remote Interface Command
CURR:UCL {<current>}
CURR:UCL?
Apply : CURR:UCL 5 Set the UCL level.
About initial OCL setting, refer to Default Setting Values of "1-6. Check After Power On"
Note
- 35 -