ODA EX Series, Брошюра и инструкция по эксплуатации

Страница: 92 / 113

EX Series Operating Manual
REM:OUTP {LOC|CONT|DIR|TTLP|TTLN}
This command is P/S output ON/OFF command. There are local mode control or 4 types
external control.
> LOC Local mode controlling. You must choose it when you use RS232 or etc.
> CONT By using external contact recovery switch, you can control the output ON/OFF.
> DIR By using external contact state switch, you can control the output ON/OFF.
> TTLP By external TTL signal, you can control the output ON/OFF. y g , y p /
High signal means output is ON.
> TTLN By external TTL signal, you can control the output ON/OFF.
Low signal means output is ON.
ex) Rem:Outp DIR You can choose direct switch programming
REM:OUTP?
This command is checking the P/S output ON/OFF control method
This command is checking the P/S output ON/OFF control method.
Return value
"LOC" Current state is local mode
"CONT"
Current state is contact switch
"DIR" Current state is direct switch
"TTLP" Current state is TTL signal positive
"TTLN" Current state is TTL signal negative
ex)Rem:Outp? return value "DIR" ) p
REM:PAR {MAST|SLAV}
This command is choosing command between master P/S and slave P/S when you make
a parallel composition with several P/S.
> MAST You set this P/S to master.
> SLAV You set this P/S to slave.
ex) Rem:Par MAST You set this P/S to master ex) Rem:Par MAST You set this P/S to master
REM:PAR?
This command is checking the P/S state between master and slave.
Return value
"MAST" Current state is master
"SLAV" Current state is slave
ex)Rem:Par? return value "MAST" )
- 92 -