NEC Express5800 140He, Руководство пользователя

Страница: 72 / 398

3-10
TURNING ON THE SERVER
T setup. urn on the server and follow the on-screen instructions for
IMPORTANT:
Before turning on the server:
„ Some optional boards require setups with the SETUP utility before installation. If the
s
utility is
e
p
n
„ Some
proce
To use th tall the
desired o
erver has a PCI board with the PCI-to-PCI bridge installed, the SETUP
nabled to launch. Check on the board specifications to find out whether it requires
re-i stallation setups before actually installing the board.
installed optional devices or connected peripheral devices require setups before
eding to the next step.
e server with no optional devices installed besides the graphic board, ins
perating system to the server.
1.
Make sure
CD-ROM
2.
Press the
th loppy disk and the CD-ROM drive contains no bootable
.
POWER switch.
at the floppy disk drive contains no f
NOTES:
„ If the power cord is connected to the power control unit such as the UPS, turn on the
power control unit.
for about 30 seconds before pressing the POWER
switch. The POWER switch does not work for about 30 seconds after connecting the
p
to BMC (Baseboard Management Controller) firmware start-up.
„
D
t
it ma
„ Connect the power cord and wait
ower cord due
o not turn off the server until characters following our logo appear on the screen. The
ime until the characters appear depends on your system configuration. Approximately,
y take one to five minutes.
POWER switch
POWER/SLEEP lamp