NEC Express5800 140He, Руководство пользователя

Страница: 184 / 398

6-8
EXPRESSBUILDER for DOS-based with Remote Console
This subsection describes the procedures for using EXPRESSBUILDER for DOS-based with remote console.
EXPRESSBUILDER contains the remote console feature that allows the system administrator to set up the server from
the management workstation (management PC) via the network or the server's COM2 (serial) port.
IMPORTANT:
„ Do not use this feature on any other computer than the server, or on any other server
obtained without EXPRESSBUILDER. Doing so may cause a failure of the server.
„ When a keyboard is connected to the server, the remote console feature is disabled.
EXPRESSBUILDER determines that the server has a console. (Nothing is displayed
on the management PC.)
Starting
The following two methods are available to start the server.
„ Running EXPRESSBUILDER from the management PC via LAN
„
Running EXPRESSBUILDER from the management PC via direct connection (COM2)
For the procedure for starting EXPRESSBUILDER for DOS-based with Remote Console, see "DianaScope".
IMPORTANT:
Do not change the boot device order in BOOT menu in BIOS SETUP.
EXPRESSBUILDER cannot be used if the CD-ROM drive is not the first device to launch
the system.
To use this feature, you need a 3.5-inch floppy disk. Please prepare a floppy disk.
NOTE: The following items of BIOS setup information will be set as shown below.
„
LAN Controller 1 (10/100): [Enabled]
„
Serial Port A: [Enabled]
Base I/O address: [3F8]
Interrupt: [IRQ 4]
„
Serial Port B: [Enabled]
Base I/O address: [2F8]
Interrupt: [IRQ 3]
„
Serial Port Address: [On-board COM B]
„ Baud Rate: [19.2k]
„ Flow Control: [CTS/RTS]
„
Console Type: [PC ANSI]