NEC Express5800 140He, Руководство пользователя

Страница: 107 / 398

4-33
Menu Description
+Fail Drive Set the disk offline
+Make HotSpare Set as stand-by disk for auto rebuilding
+View Drive Information Display hard disk information
•
Device Type
Hard disk type
•
Capacity
Hard disk capacity
•
Vender ID
Hard disk vender name
•
Product ID
Hard disk model
•
Revision
Hard disk revision
•
SCSI Standard
SCSI standard
•
Media Errors
The number of media errors
•
Other Errors
The number of other errors
*16
‘
Synchronous Negotiation SCSI synchronous negotiation
*17
‘
SCSI Command Q Tagging Set SCSI command Q Tag
+Channel Set channel
+Channels Chose SCSI channel
*18
‘
Termination State Set termination state
*19
‘
Enable Auto Termination Set auto termination state
*20
‘
SCSI Transfer rate Set transfer rate
+Format Perform low level format *Do not use
+Rebuild Perform rebuilding
+Check Consistency Perform logical drive redundancy check
+Select Adapter Select disk array controller
* This menu item does not appear if no disk array controller is installed
in the computer.
Setting values
No. Setting parameter Factory setting Setting change
*1 FlexRAID PowerFail ENABLED Do not change
*2 Fast Initialization ON Variable setting
*3 Disk Spin-up Timing 2 disks every 6 secs Do not change
*4 Cache Flush Timing Every 4 Seconds Do not change
*5 Rebuild Rate 30% Variable setting
*6 Alarm Control Disable Alarm Do not change
*7 Disable(Enable) BIOS Enable (Display: Disable BIOS) Do not change
*8 Emulation MASS STORAGE Do not change
*9 Auto Rebuild ENABLED Do not change
*10 Cluster Mode DISABLED Do not change
*11 Multiple PCI Delayed Trans ENABLED Do not change
*12 Force Boot ON Do not change
*13 Coercion Algorithm NONE Do not change
*14 CC Restoration ENABLED Variable setting
*15 Temporary Offline RAID ENABLED Do not change
*16 Synchronous Negotiation Enabled Do not change
*17 SCSI Command Q Tagging Enhanced QTAG Scheduling Do not change
*18 Termination State Enabled Do not change
*19 Enable Auto Termination No Do not change
*20 SCSI Transfer rate 320M Do not change
Changing factory settings
The settings for the following items can be changed. Follow each explanation:
*2 Fast Initialization A setting of "On" is recommended.
This initializes the top area of the disk only.
*5 Rebuild Rate A setting of "30%" is recommended.
*14 CC Restoration Factory setting is "ENABLED".