NEC Express5800 140He, Руководство пользователя

Страница: 55 / 398

2-25
„
T T
F1
If me to resume" appears, an error is detected during POST. See
"E
actions
setup u
ssage "Press <F1>
rror messages during POST" for the information on the messages and the proper
against the errors. If an error message appears, pressing
F1
allows the BIOS
tility to be started.
7.
When a passw y SETUP, the screen prompting you to enter the password
appears after th
p
er
on th
I
ord is set in the BIOS setup utilit
e normal termination of POST.
The assword can be entered for up to three times. If you enter the password incorrectly all the time, the
serv cannot be started. In this case, turn off the power of the server, wait for about 10 seconds, and then turn
e power to start the server again.
MPORTANT:
Set the password only after operating system is installed.
8.
Starts
POST Error Messages
When PO e apter 8 for POST error codes.
IMPORTANT:
Take a note on the messages displayed before contacting your service
operating system at the termination of POST.
ST d tects an error, it displays an error message on the screen. See Ch
representative. Alarm messages are useful information for maintenance.
Po
Follow the procedure b
manual that comes w
IMPORTANT: Always allow POST to complete before turning off the server.
wer Off
elow to power off the server. If the power cord of the server is connected to a UPS, refer to the
ith the UPS or the manual for the application that controls the UPS.
1.
Shut down the operating system.
3.
Power off peripheral devices.
2.
Press the POWER switch on the front of the server.
The POWER/SLEEP lamp goes off.