Myray hyperion X9, Руководство оператора

Страница: 15 / 1226

EN OPERATOR'S MANUAL
15
Guidance and manufacturer’s declaration – Electromagnetic immunity
The hyperion X9 is suitable for use in the specified electromagnetic environment. The purchaser or user of the
hyperion X9 should assure that it is used in an electromagnetic environment as described below:
Immunity Test
IEC 60601-1-2
Test level
Compliance
level
Electromagnetic Environment
Electrostatic
discharge (ESD)
IEC 61000-4-2
6 kV contact
8 kV air
IEC 60601-1-2
Test level
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Electrical fast
transient/burst
61000-4-4
2 kV for power
supply lines
1 kV for input/output
lines > 3 m
IEC 60601-1-2
Test level
Mains power quality should be that of a
typical commercial or hospital environment.
Surge
IEC 61000-4-5
1 kV differential mode
2 kV common mode
IEC 60601-1-2
Test level
Mains power quality should be that of a
typical commercial or hospital environment.
Voltage dips, short
interruptions
and voltage
variations on power
supply input lines
IEC 61000-4-11
0% U
n
for 0.5 cycles
40 % U
n
for 5 cycles
70 % U
n
for 25 cycles
0 % U
n
for 5 s
IEC 60601-1-2
Test level
Mains power quality should be that of a
typical commercial or hospital environment.
If the user of the hyperion X9 requires
continued operation during power mains
interruptions, it is recommended that the
hyperion X9 be powered from an
uninterruptible power supply or a battery.
Power frequency
(50/60 Hz)
magnetic
field
IEC 61000-4-8
3 A/m
IEC 60601-1-2
Test level
Power frequency magnetic fields should be
at levels characteristic of a typical location
in a typical commercial or hospital
environment.
Guidance and manufacturer’s declaration – Electromagnetic immunity
The hyperion X9 is intended for use in the electromagnetic environment specified below. The customer or the user
of the hyperion X9 should assure that it is used in such an environment.
Immunity Test
IEC 60601-1-2
Test level
Compliance
level
Electromagnetic Environment
Portable and mobile RF communications
equipment should be used no closer to any
part of the hyperion X9, including cables,
than the recommended separation distance
calculated from the equation applicable to
the frequency of the transmitter.
Recommended separation distance.
Radiated RF
EN 61000-4-3
3 V/m
80 MHz to 2.5 GHz
3 V/m
d = 1.2 x √P 80 MHz to 800MHz
d = 2.3 x √P 800 MHz to 2.5GHz
Conducted RF
EN 61000-4-6
3 V
150 kHz to 80 MHz
3 V
d = 1.2 x √P
Where P is the maximum output rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in
meters (m).
Field strengths for fixed RF transmitter, as
determined by an electromagnetic site
survey, should be less then the compliance
level in each frequency range interference
may occur in the vicinity of equipment
marked with the following symbol: