© MOOG 2010
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
50
MRJ04410
STATUS INDICATORS
Two status indicators are shown on the Profile page. (
Figure 2-5 DigiPackⅡFront Panel
)
Running or Ready
Die gap and Delay are not highlighted
Die gap
Die gap is highlighted
Delay
Delay is highlighted
Status Condition
Running or Ready:
1)
When the mode is changed from MANUAL to AUTO
2)
When the power is turned on or the DigPack is reset
3)
When the STOP signal is input
4)
End of movement of the Delay to until Diegap signal ON.
Die gap: From DieGap signal and while core on the Die gap position
Delay: From Start signal and while Delay running
2-3-3.
LCD (LIQUID CRYSTAL DISPLAY)
The LCD Display shows the detailed screen used when a
particular Function is selected.
Selection of the individual Function Items is done by the
Cursor. In
Figure 2-6 LCD Display
, the value of the Item
Shot Size, 10.0 sec, is highlighted and therefore Shot Size is
selected. Turning the Entry Knob will increase (CW) or de-
crease (CCW) the Shot Size value. To make this Shot Size
change permanent, Set must be pressed. If Set is not
pressed, then the value of Shot Size will return to its origi-
nal value.
Selection of other Function Items is done by repeatedly
pressing the Up or Down Cursor until the desired Item is
reached. In this manner, all of the individual Function Items
may be selected. The value of any Function Item will not be
changed when moving between Function Items unless Set is
pressed.
This input procedure applies to all Function screens.
Figure 2-6 LCD Display
