Mitsubishi Q00CPU, Руководство пользователя

Страница: 596 / 976

9
- 22 9.1 PLC Parameters
9.1.2 High Performance model QCPU, Process CPU, Redundant CPU, Universal model QCPU
9
PARAMETERS
* 1: When changing the device points, the refresh ranges of the network modules and the auto refresh
ranges of the intelligent function modules must be set so as not to be out of the out of the
corresponding device points.
If the device points are set exceeding the corresponding device range, the data may be written
into other devices or an error may occur.
* 2: For the Universal model QCPU, the latch clear cannot be made by the switch operation.
* 3: Setting in the range is allowed for the Universal model QCPU.
* 4: For the Universal model QCPU, the scan time is prolonged when the device is latched. When
latching a device, consider the prolonging scan time. ( Section 10.1.2 (11))
* 5: In the Universal model QCPU whose serial number (first five digits) is "10042" or later, 0 point can
be set for step relays (S).
* 6: Setting is allowed only when the Universal model QCPU is used.
* 7: Setting is allowed only when the Universal model QCPU whose serial number (first five digits) is
"10042" or later.
Table9.18 Device list (Continued)
Item Parameter No. Description Setting range Default value Reference
File
register
extended
setting
*6
Dev. point 2000
H
Set the number of file register
(ZR), extended data register (D),
and extended link register (W)
points.
• Number of points set for the
file register (ZR)
• Assign a part of the points set
for the file register to the
extended data register (D) or
the extended link register.
No setting
Section 10.2
Section 10.8
Latch (1)
start/end
(Latch
clear
enabled)
2004
H
Set the latch range (start device
number/end device number) that
can be cleared with the remote
latch clear operation. Each latch range of the file
register (ZR), extended data
register (D), and extended link
register (W)
No setting
Section 3.7
Section 6.3
Latch (2)
start/end
(Latch
clear
disabled)
2005
H
Set the latch range (start device
number/end device number) that
cannot be cleared with the
remote latch clear operation. Each latch range of the file
register (ZR), extended data
register (D), and extended link
register (W)
No setting
Section 3.7
Section 6.3
Indexing setting of ZR
device
*7
2000
H
Set whether to use the Z device
or the ZZ device with the 32-bit
index modification.
• Z0 to 18 (When using the Z
device)
Use Z
QCPU (Q
Mode)/QnACPU
Programming
Manual
(Common
Instructions)