Mitsubishi Electric GOT 1000 Series, Руководство по подключению

Страница: 380 / 436

12 - 12
12. CONNECTION TO TOSHIBA PLC
12.3 Ethernet Connection
12.3.3 PLC side setting
POINT POINT POINT
TOSHIBA PLC
For details of TOSHIBA PLCs, refer to the following
manual.
TOSHIBA PLC user's Manual

Setting of operation mode switch and station
No. switch
(1) Station No. setting switch
The station No. setting switches are hexadecimal rotary
switches that determine the station No. on the Ethernet
network.
Set the station address (1 to 254) that has been
assigned upon system configuration in a HEX code.
Assign an address with a different value to each of the
nodes in the system.
(2) Operation mode setting switch
*1 XX indicates the value of the station No. setting switches.
Subnet mask : 255.255.192.0
*2 XX indicates the value of the station No. setting switches.
Subnet mask : 255.255.255.0
*3 It can be set freely from the engineering tool, and the value
has precedence over the value of the station No. setting
switches.
12.3.4 Precautions

Delay of device communication
Note that if a non-existent station, or a station which
power is turned OFF is monitored, the communication
of normal stations is also delayed.

Redundant system
When configuring a redundant system, the "Multicast
address setting" for the configured PLC pair (System A:
Primary, System B: Secondary) is required.
Switch name Setting details Setting range
STN-H Upper address : 0 to F (Hex.)
01 to FE (Hex.)
STN-L Lower address : 0 to F (Hex.)
Operation mode
setting switch
Station No.
setting switch
Description Settings
Switch No.
1 2 3 6 7 8
Operation
mode
Normal OFF OFF OFF
For maintenance
ON OFF OFF
OFF ON OFF
IP address
type
Class B
172.16.64.XX
*1
OFF OFF OFF
Reserved OFF ON OFF
Class C
192.168.0.XX
*2
OFF OFF ON
Tool setting
*3
ON ON ON