Mitsubishi Electric GOT 1000 Series, Руководство по подключению

Страница: 280 / 436

7 - 26
7. CONNECTION TO KOYO EI PLC
7.5 PLC Side Setting
7.5.7 Connecting to D0-DCM

Communication settings
Write the following communication settings to the
specified register using the programmer.For details of
the register, refer to the following manual.
KOYO EI PLC user's Manual
*1 Indicates only the transmission speeds that can be set on
the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to
the following.
7.4.1 Setting communication interface
(Communication settings)
7.5.8 Connecting to D2-DCM

Communication settings
Make the following settings using the programmer.
*1 Indicates only the transmission speeds that can be set on
the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to
the following.
7.4.1 Setting communication interface
(Communication settings)
7.5.9 Station No. settings
Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
(1) Direct specification
Specify the station No. of the PLC to be changed when
setting device.
Item Set value
Transmission mode HEX
Protocol DirectNet
Station No. 1 to 90
Transmission speed
*1
9600bps, 19200bps, 38400bps, 57600bps,
115200bps
Parity
NONE, ODD,
EVEN (Only communication port 2)
RTS On Delay Time
(Only communication port 2)
0ms
RTS Off Delay Time
(Only communication port 2)
0ms
Timeout
(Only communication port 2) 800ms/960ms/1200ms/1600ms/4000ms/
8000ms/16000ms/40000ms
485 mode selection
(Only communication port 2)
RS232, RS422/485 4 line type
Data bit
(Only communication port 2)
8bits, 7bits
Stop bit
(Only communication port 2)
1bit, 2bits
The timeout between
characters
(Only communication port 2)
0 to 9999ms
The completion of a
setting
Default use,A preset value is effective
Reset timeout Invalid,Effective
Item Set value
Station No. 1 to 90
Transmission speed
*1
9600bps, 19200bps, 38400bps
Data bit 8bits (Fixed)
Stop bit 1bit (Fixed)
Parity NONE, ODD
Self-diagnostic mode OFF
Response delay time 0ms
Peer to Peer OFF
Master/Slave Slave
Timeout Enable
Transmission mode HEX
MODBUS OFF
Specification range
1 to 90
The example of a Station No. setting
Station No.3
Station No.1 Station No.15
GOT