Mercedes-Benz EQS 2023, Руководство оператора

Страница: 444 / 590

R
The vehicle is on solid, non-slippery and level
ground.
R
The required tire-change tool kit is available.
%
If your vehicle is not equipped with the tire-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
#
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
position.
#
Shift the transmission to position
j
.
#
Set the raised vehicle level for greater ground
clearance (
/
page 281).
#
Switch off the vehicle.
#
Make sure that the vehicle cannot be started.
#
Place chocks or other suitable items under the
front and rear of the wheel that is diagonally
opposite the wheel you wish to change.
#
Unload the vehicle.
Removing and installing the wheel trim/hub caps
Requirements
R
The vehicle is prepared for a wheel change
(
/
page 441).
Wheel trim
The wheel trim covers the wheel bolts on vehicles
with aluminum wheels. Before unscrewing the
wheel bolts, remove the wheel trim.
#
To remove: using both hands, carefully reach
into two wheel trim openings and remove the
wheel trim.
#
To install: place the wheel trim in position and
press firmly until it engages.
Raising the vehicle when changing a wheel
Requirements
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 441).
Important notes on using the jack:
R
Use only a vehicle-specific jack that has been
approved by Mercedes-Benz to raise the vehi-
cle.
R
The jack is only designed for raising and hold-
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
R
The foot of the jack must be positioned verti-
cally under the jack support point.
442 Wheels and tires