Mercedes-Benz EQS 2023, Руководство оператора

Страница: 233 / 590

#
Press and hold button
1
,
2
or
3
that you
wish to program.
Indicator lamp 4 flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
#
Release the previously pressed button.
Indicator lamp 4 continues to flash yellow.
#
Point remote control 5 from a distance of
0.4 in (1 cm) to 3 in (8 cm) towards button
1 , 2 or 3 .
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green continu-
ously. Programming is complete.
R
Indicator lamp 4 flashes green. Program-
ming was successful. Additionally, syn-
chronization of the rolling code with the
door system must be carried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
▌ Synchronizing the rolling code
Requirements
R
The door system uses a rolling code.
R
The vehicle must be within range of the garage
or door drive.
R
The vehicle as well as persons and objects are
located outside the range of movement of the
door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1 , 2
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
% Please also read the operating instructions for
the door drive.
▌
Troubleshooting when programming the remote
control
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles from
a distance of 0.4 in (1 cm) to 3 in (8 cm) in
front of the inside rearview mirror. You should
test every position for at least 25 seconds
before trying another position.
#
Hold remote control 5 at the same angles at
various distances in front of the inside rear-
view mirror. You should test every position for
at least 25 seconds before trying another
position.
#
On remote controls that transmit only for a
limited period, press button
6
on remote
control
5
again before transmission ends.
#
Angle the antenna line of the garage door
opener unit towards the remote control.
Driving and parking 231