Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 328 / 370

320
4. When the hole of the inner rod (6) for 0 degree angled Fly-jib
and the hole of the outer rod (5) match, insert the position pin
(7) to the holes and insert the linchpin (25). When inserted,
ensure the ring is turned to lock it.
5. Remove the lever block (23).
[Posture of the 0 degree angled Fly-jib]
CAUTION
The posture shown in the right figure is a
posture when the Fly-jib angle is zero
degrees.
[Posture of the 60 degrees angled Fly-jib]
CAUTION
The posture in the figure below right shows
that the Fly-jib is configured to 60 degrees
tilt angle from [Posture of the 0 degree
angled Fly-jib] as above.
To change the Fly-jib tilt angle to 60 degrees:
(1) Continue the boom derricking operation
and the procedure specified in 3 above
(un-winding the lever block) alternately
to allow the Fly-jib angle to be gradually
adjusted.
(2) Match the hole of the outer rod and the
the hole of the inner rod for 60 degrees
angled Fly-jib.
(3) When the hole of the inner rod (6) for 60
degrees angled Fly-jib and the hole of the
outer rod (5) match, insert the position
pin (7) to the holes and insert the linchpin
(25). When inserted, ensure the ring is
turned to lock it.
• To change the Fly-jib tilt angle to 40
degrees, practice similarly as above to
obtain the Fly-jib tilt angle of 40 degrees.
• To change the Fly-jib tilt angle to 20
degrees, use only the lever block function
to obtain the Fly-jib tilt angle of 20
degrees.
When the Fly-jib angle is changed, the Fly-jib
angle display on the monitor is switched to
the angle value after the change.