Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 251 / 370

243
(8) One or more strand is loosened.
(9) Wires that are noticeably sticking out.
5. An end socket that is found faulty.
[REMOVAL OF WINCH WIRE ROPE]
Always put on thick leather work gloves when handling the wire rope.
CAUTION
After lowering the hook block on the ground, an attempt of further unwinding give rise
to the irregular winding of wire rope on the winch drum. When the hook block has been
lowered on the ground, never try to unwind the rope.
Use the following procedure to remove the wire rope.
1. Stop the Machine on solid ground, fully retract the
boom and set the boom angle to approximately 20
degrees.
2. Unwind the winch from the state under item 1 above to
unwind the hook block until it is almost touching the
ground.
3. Bring down the hook block to the ground by
performing the boom derricking down operation.
4. Remove the wire socket fixing bolt (1), pull off the wire
socket pin (2) and remove the wire socket (3).
5. Remove the wire clip (4).