Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 269 / 370

261
[2] OIL LEVEL CHECK AND REFILLING IN WINCH REDUCTION GEAR CASE
• Various parts are at elevated temperatures immediately after stopping the engine
operation. Do not check oil level immediately. Wait until the oil is cooled.
• If there remains a residual internal pressure of the case, the oil and the plug may jump
out. Accordingly, slowly loosen the plug to relieve the pressure.
CAUTION
• See “MAINTENANCE 7.1 USE OF FUEL AND LUBRICATING OIL ACCORDING TO
TEMPERATURES” for the oil to be used.
• Use seal tape, etc. to the thread of the oil level check plug to stop oil leaks and
securely tighten the plug after checking/refilling the oil.
• Prepare a container to receive spent oil.
• Have a hexagonal wrench available.
1. Stop the Machine on flat and solid ground, raise the
boom to approximately 80 degrees.
2. By using a hexagonal wrench, remove the oil level
check plug (G) and ensure that the level is within the
normal range from the lower end of the plug opening to
10mm below.
3. If the oil level is low, remove the oil inlet plug (F) and
feed oil through the plug hole.
NOTES
·
Fill the oil until it overflows from the oil level check plug
hole (G).
·
Wipe clean any spilt oil.
4. After checking and refilling oil, mount the oil inlet plug
(F) and oil level check plug (G) and securely tighten
them.