Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 109 / 370

101
For wire rope, safe load per rope fall is determined.
Determine the number of falls according to the maximum
hoisting load.
Be sure to match the actual number of wire falls of the hook
with the number of wire falls displayed on the monitor.
This machine is equipped with a hook that serves for both
4 and 2 wire ropes as standard specifications.
For the set value of the number of wire falls, the last state
is memorized when the starter switch is turned to the "OFF"
position.
See "OPERATION 2.1.1 [2-3] HOOK SLING NUMBER
CHANGE" for the change of the number of wire falls.
[8] BOOM LOWER LIMIT DETECTION
When the boom length is "5.3m" or longer, the boom lowering action stops automatically so that the
boom does not fall below the horizontal line.
[9] STATIONARY AND TRAVEL MODE CHANGE DISPLAY
Travel with a lifted load is in principle not advisable because it is very unstable and involves
danger.
If travel with a lifted load is unavoidably performed, see "OPERATION 3.24 OPERATION
DURING TRAVELLING HOIST " and strictly observe the rated total load, operation method
and travel posture with a lifted load at the time of travel with a lifted load.
Unless these precautions in traveling with a lifted load are observed, serious physical injury
may be caused.
When traveling with a lifted load, use this to change from
the stationary mode to the travel mode.
•
Press and hold the switch. The rated load setting changes
to "Travel mode" and the monitor display changes.
•
Press and hold this switch again. The rated load setting
changes to "Stationary mode" and the monitor display
changes.
NOTES
•
When the boom length is "10.6m" or longer, travel is
prohibited and the mode cannot be set to the travel mode.
When setting the mode to the travel mode, make
arrangements so that the boom length is "10.5m" (three
stage boom) or less.