Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 205 / 370

197
5. TRANSPORTATION
Observe the related regulations and exercise safety during transport.
5.1 LOADING/UNLOADING
• See "SPECIFICATION 1. MAIN SPECIFICATION TABLE" for the dimensions and mass of
this machine.
•
Select ramp boards to be used which satisfies the following conditions.
•
Length must be such that the setting angle onto a trailer is 15 degrees or less.
•
The width must be such that the crawler does not protrude from the ramp boards.
•
The thickness and strength must be such that can fully stand the mass of this machine.
•
Set the ramp boards at right angles to the trailer bed.
Align the center of the right and left crawlers with
the center of the respective ramp boards. If the
ramp boards are bent or the center of the crawler
is off, the machine may fall from the ramp boards,
causing serious physical injury.
• Always put the machine in the “travelling posture”
when loading/unloading the machine. See
“OPERATION 3.7 TRAVELLING POSTURE OF
MACHINE” for details.
•
Be sure to turn the auto deceleration switch to "OFF" (Cancel). If the machine is operated
with the auto deceleration switch turn "ON" (Operation), the machine may make a sudden
start.
•
Be sure to set the travelling speed to the low speed range (LO) and load and unload the
machine with engine speed set to low speed.
• Always move backward when loading the Machine. Moving forward may cause the machine to fall.
• Always move forward when unloading the Machine. Moving backward may cause the machine
to fall.
• Be especially careful when loading or unloading the Machine because the risks intervene.
• Select a location that is level and has firm road surface when loading or unloading the
Machine.
In addition, keep enough distance from the roadside.
• Remove the mud and other substances from the footing to prevent the Machine from
skidding over the ramps.
• Remove the substances stuck on the ramp boards such as grease, oil, snow or ice, and keep
clean.
• Never change direction over the ramp boards. Temporarily leave the ramp boards before
correcting the direction.
•
As the center of gravity position of the machine suddenly shifts at a boundary between
the ramp and trailer, balance is lost, causing danger. Pass the ramp slowly.
• Check that the cab slide door is securely locked when it is closed and opened. Avoid
opening/closing the door on the ramp boards or forwarding blocks because the operating
force may change suddenly.